Slide vertical height adjustment

  • 06/14/2017 10:02 PM
    Message # 4901141

    the front slide on our 2016 Excursion 33D, has settled down about 1/4 inch in the front (I can tell how much measuring the drop of the paint swooshes on the side below the rest of the rig)...the slide works fine in and out, but the trim on the slide is almost to the trim of the box when the slide is in....is there any adjustment I can do to raise it, or is this and RV tech issue?...thanks, Mel 

  • 06/15/2017 10:09 AM
    Reply # 4901885 on 4901141

    I ran into a similar (but more serious) issue with my 2015 Bounder on some camping trips last summer. As we were preparing to leave camp, we discovered that the slide would not fully retract (short by about 6 inches). The slide was running into the ramp for the rollers. I called a local service provider and the solution was adjusting the level on the slide. I did not personally make the adjustment.

    Unfortunately, the same thing occurred again on a subsequent trip. My final solution was to take it to the Fleetwood service center for resolution. 

    There were two bolts where the slide connects to the slide mechanism and I believe a 3rd bolt that made the adjustment. Mine needed the adjustment on both ends of the slide. But you have to love the paint schemes to notify you when your off 8-)


©2012 all rights reserved, Fleetwood Motorhome Association.                                                                             Contact Us | Privacy Policy

Powered by Wild Apricot Membership Software